Toro Outcross 9060 Service Manual page 90

Removing the Engine (continued)
Engine: Service and Repairs
To prevent damage to the fuel hoses, numerous cable ties and
clamps are used to secure the hoses to the machine components.
Record the location of all cable ties and clamps that are removed
from the machine so they can be properly replaced.
7. Disconnect the fuel hoses; refer to
A. Disconnect the hose between the engine fuel filter and the fuel cooler at
the engine fuel filter.
B. Disconnect the hose between the electric fuel pump and the engine fuel
filter at the engine fuel filter.
C. Disconnect the hose between the fuel cooler and the fuel tank at the
fuel cooler.
D. Cover or plug the fuel hoses or fitting openings to prevent contamination
from entering the fuel system.
If the radiator or engine is hot, pressurized hot coolant can escape
and cause burns.
Do not open the radiator cap or drain the coolant when the radiator
or engine is hot.
Ethylene-glycol antifreeze is poisonous.
Keep the coolant away from children and pets.
Keep the coolant in a labelled container.
Discard the coolant in accordance with local hazardous waste
ordinances.
8. Disconnect the reservoir hose at the radiator and remove the coolant
reservoir assembly.
9. Drain the coolant from the radiator.
10. Disconnect the upper and lower radiator hoses from the radiator. Cover or
plug the disconnected coolant hoses to prevent contamination.
Note: The lower hydraulic hose can be easily disconnected at the bulkhead
below the vehicle frame.
11. Refer to General Precautions for Removing and Installing the Hydraulic
System Components (page 5–49)
the cooler.
12. Remove the top nut plate and the fan shroud. Reinstall the top nut plate.
13. Remove the 4 flange nuts and carriage screws securing the radiator mount
assembly to the frame and remove the radiator assembly from the machine.
IMPORTANT
Fuel System (page
DANGER
WARNING
and disconnect the hydraulic lines from
Page 4–18
4–14):
Outcross 9060
18234SL Rev B