Toro Outcross 9060 Service Manual page 35

Outcross 9060
18234SL Rev B
High Flow Hydraulic Filter Kit
Toro Part Number: TOR6011
The high flow hydraulic filter kit is designed with
large flow (150 LPM or 40 GPM) and high pressure
(34,500 kPa or 5,000 psi) capabilities. This kit
provides for bidirectional filtration which prevents
filtered unwanted material from entering into the
circuit regardless of the flow direction.
If a component failure occurs in the closed-loop
traction circuit, contamination from the damaged
part will remain in the circuit until you remove it.
Install a high flow hydraulic-fluid filter into the circuit
when you connect the hydraulic test gauges in
order to test the traction circuit components or after
you replace a failed traction circuit component
(e.g., piston pump or wheel motor). This filter
removes contamination from the hydraulic fluid in
the traction circuit, thereby preventing additional
component damage. Refer to
Closed-Loop Traction Circuit (page 5–54)
additional information.
Note: This kit does not include the hydraulic hoses;
refer to Hydraulic Hose Kit (page
Note: The replacement filter element is Toro
Part No. TOR6012. The filter element canister
tightening torque is 34 N∙m (25 ft-lb).
Remote Starter Switch
After flushing the hydraulic system or
replacing a hydraulic component (e.g.
gear pump, piston pump, drive motor), it is
necessary to prime the hydraulic pumps.
A remote starter switch can be used for
this purpose. A remote starter switch
can be purchased locally or fabricated as
follows.
IMPORTANT: When using a
remote starter switch, it is highly
recommended to include a 20 amp
in−line fuse between the battery and
switch connector for circuit protection.
A remote stater switch can also be
constructed using Toro switch #106−2027,
a length of 14 gauge wire, a 20 amp
in−line fuse, two (2) alligator clips and
necessary connectors. Connecting the
wire to switch terminals 1 and 2 will allow
the momentary switch contacts to be used
for the remote starter switch.
Note: For information on using the remote
starter switch to prime the hydraulic
pumps; refer to Priming the Hydraulic
Pumps (page 5–58).
Filtering the
for
2–15).
Remote Starter Switch (purchased)
Remote Starter Switch (fabricated)
Page 2–17 Specifications and Maintenance: Special Tools