Toro Outcross 9060 Service Manual page 231

Status Display Controller (T2: TDM) (continued)
Outcross 9060
18234SL Rev B
T2: TDM Inputs
INPUT NUMBER
IN 2
Increase/Decrease
Switch – Decrease
IN 3
IN 4 Economy (ECO)
IN 5
Off/On/Set Switch
IN 6
Off/On/Set Switch
T2: TDM Outputs
OUTPUT NUMBER
OUT 1
OUT 2
OUT 3
The machine electrical schematic and wire harness drawings in
A (page A–1) can be used to identify possible circuit problems between the
controller and the input or output devices.
When testing for wire harness continuity at the connector for
the controller, take care to not damage the connector pins with
multimeter test leads. If connector pins are enlarged or damaged
during testing, connector repair may be necessary for proper
machine operation.
g259386
1. Platform wire harness connector P15
DESCRIPTION INPUT NUMBER
Cruise Speed
Differential lock
switch
Mode Switch
Cruise Control
– ON (enable)
Cruise Control
– SET (engage)
IMPORTANT
Figure 82
2.
Page 6–23 Electrical System: Electrical Component Testing
DESCRIPTION
IN 7
Cruise Speed
Increase/Decrease
Switch – Increase
AIN1 Mode Selector Switch
AIN2 Status Display Button
AIN3 Hydraulic Fluid
Temperature Sender
AIN4 Fuel Level Sender
DESCRIPTION
Parking Brake Light
Not Used
Warning Buzzer
Appendix
Status display controller (T2: TDM)