Toro Outcross 9060 Service Manual page 336

Removing the Steering Wheel, Instrument Panels and Dash Cover
Installing the Steering Wheel, Instrument Panels and Dash Cover
Chassis: Service and Repairs
1. Park the machine on a level surface, lower any attachments, shut off the
engine and remove the key from the key switch.
2. Disconnect the battery; refer to
3. Remove the steering wheel. If necessary, use a suitable puller to remove the
steering wheel from the steering column.
Note: The main instrument panel can be passed through the dash cover
opening without disconnecting all the controls from the wire harness.
4. Remove the main instrument panel. If necessary, label all the wire harness
connections for assembly purposes and disconnect the wire harness from
the panel controls.
5. Remove the windshield from machines with a cab.
6. Remove the steering instrument panel. Label all the wire harness
connections for assembly purposes and disconnect the wire harness from
the panel controls.
7. Remove the steering column cover.
8. Remove the console instrument panel fasteners and move the panel to allow
access to the 2 dash cover to console fasteners.
9. Remove the dash cover.
1. Install the dash cover.
2. Install the 2 dash cover to console fasteners, then install the console
instrument panel.
3. Install the steering column cover.
4. Install the steering instrument panel.
5. Install the windshield from machines with a cab.
6. Install the main instrument panel.
7. Apply a thin coating of anti-seize lubricant to the steering column splines and
install the steering wheel, washer and lock nut. Tighten the lock nut from 28
to 35 N∙m (20 to 26 ft-lb).
8. Connect the battery; refer to
9. Verify instrument panel controls function before returning the machine to
service.
Removing the Battery (page
Installing the Battery (page
Page 8–16
6–81).
6–81).
Outcross 9060
18234SL Rev B