Toro Outcross 9060 Service Manual page 161

Removing the Tandem Piston (Traction) Pump (P1) and (P2) (continued)
Outcross 9060
18234SL Rev B
6. Remove the manifold support assembly.
7. Remove the air flap (item 2 in
8. Label and disconnect the wire harness at the 4 piston pump servo control
solenoid coils.
9. Label and disconnect the wire harness at the 2 traction pressure sensors.
10. To prevent contamination of the hydraulic system during gear pump and
piston (traction) pump removal, thoroughly clean the exterior of the gear
pump, piston pump, and all fittings and hose/tube connections.
11. Disconnect the suction hose from the bottom of the gear pump and the
pressure hoses from the top of the gear pump. Put plugs in the open
hydraulic hoses. Label disconnected hydraulic hoses for proper reassembly.
12. Mark the fitting orientation to allow for correct assembly then remove the
fittings from the gear pump and discard the O-rings.
13. Remove the 2 cap screws and plain washers that secure the gear pump to
the piston pump and slide the gear pump rearward and out of the machine.
14. Plug the gear pump ports, then locate and discard the O-ring between the
gear pump and the piston pump.
15. Label and remove all of the hydraulic lines that connect to the piston pump.
Install plugs or caps on disconnected hydraulic hoses and fittings to prevent
contamination of the hydraulic system.
g267355
1. Tandem piston (traction) pump
2. R-clamp
3. Hanger plate
16. Remove the R-clamp (item 2 in
Figure 29).
Figure 41
4. Traction pressure sensor – front
5. Traction pressure sensor – rear
Figure 30) from the hanger plate.
Page 5–65 Hydraulic System: Service and Repairs