Removing and Installing the Hood
Outcross 9060
18234SL Rev B
1. Park the machine on a level surface, lower any attachments, shut off the
engine and remove the key from the key switch.
2. Release the hood latches and raise the hood.
3. Disconnect the hood from the platform wire harness.
4. Support the hood and remove the fasteners at either end of the hood prop.
The hood assembly is bulky. The hood assembly can safely be
removed by two technicians, one on each side of the machine.
5. Remove the lynch pins from the hood hinge and remove the hood.
6. Inspect the hood for worn or damaged seals (radiator area) and replace
them as necessary.
7. To install the hood, follow this procedure in reverse order.
CAUTION
Page 8–5
Chassis: Service and Repairs