PTO Clutch Service (continued)
Traction and PTO Drive: Service and Repairs
5. Remove the clutch piston then remove and discard the piston O-ring.
6. Remove the external retaining ring then remove and discard the entire brake
disc pack.
7. Install the new brake disc pack. Install the retaining ring and align the steel
tabs.
Note: Do not twist, nick, cut or otherwise damage the piston O-ring during
installation or assembly.
8. Lubricate the new O-ring with petroleum grease and install onto the piston,
then carefully fit the piston into the basket.
Note: Be careful not to scratch or otherwise damage the surface of the clutch
shaft when installing the retaining ring.
9. Install the spring and thrust washer on the clutch shaft. Compress the spring
and install the retaining ring.
10. Install the clutch disc pack in the basket and install the retaining ring.
11. Coat the needle bearing with oil and install one of the thrust washers, needle
bearing, 77T gear, remaining thrust washer and the retaining ring onto the
clutch shaft.
12. Press a new bearing onto the clutch shaft.
13. Remove and discard the clutch shaft O-ring in the rear gear box housing.
14. Lubricate the new clutch shaft O-ring with petroleum grease and install onto
the rear housing.
Page 7–20
Outcross 9060
18234SL Rev B