Installing the Selector Control Valve Manifolds
Hydraulic System: Service and Repairs
1. Lubricate new O-rings and place them onto the fittings. If previously removed,
install the fittings into the valve ports; refer to
(SAE Straight Thread O-Ring Fittings) (page
2.
Position the manifolds to the bracket and secure with 2 cap screws.
3. Remove the caps and plugs from the fittings and hoses. Properly connect
the hydraulic lines to the manifold; refer to
Tubes (O-Ring Face Seal) (page
4. Connect the wire harness connectors to the cartridge valve solenoids.
5–8).
Page 5–110
Installing the Hydraulic Fittings
5–10).
Installing Hydraulic Hoses and
Outcross 9060
18234SL Rev B