Toro Outcross 9060 Service Manual page 46

Machine Faults (continued)
Fault ID Fault Title
P0617 Engine Start
Output - Short
to Battery
P06E9
Starter
Time-out
P0939 Hydraulic Fluid
Temperature
Sender - Short
to Ground
P0940 Hydraulic Fluid
Temperature
Sender - Open
Circuit
P100C Engine
Coolant
Temperature
Above
Threshold -
PTO Disabled
P100D Engine
Coolant
Temperature
Above
Threshold -
Engine Shut
Down
P1104 Traction
Coil (front
pump forward
valve - C1)
Overcurrent
Troubleshooting: Attachment/Loader Problems
Controller
Fault Description
Action
Low current detected
on engine start output
. Indicates a short to
battery
Starter has been Starter output is
engaged continuously disabled
for more than 30
seconds
Short to ground
detected on hydraulic
temperature sender
Open circuit detected on
hydraulic temperature
sender
Engine coolant PTO is disabled
temperature has
exceeded 105° C (221°
F)
Engine coolant Engine is shut
temperature has down
exceeded 115° C (239°
F)
Overcurrent detected.
Indicates a short to
ground.
Recommended Service Actions
1. Check the engine start output circuit wiring
and all of the output circuit connectors
2. Test the engine start output circuit wiring
between T1: TEC and Engine ECU
3. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
1. Check key switch is not stuck in start
position
2. Test key switch and replace if necessary
3. Test start relay and replace if necessary
1. Check temperature sender wiring and
connector
2. Test temperature sender and replace if
necessary
1. Check temperature sender wiring and
connector
2. Test temperature sender and replace if
necessary
1. Allow engine to cool
2. Check fan condition and operation
3. Clear air flow passages
4. Check coolant level and condition, adjust
and replace as necessary
5. Check temperature sender wiring and
connector
6. Test temperature sender and replace if
necessary
1. Allow engine to cool
2. Check fan condition and operation
3. Clear air flow passages
4. Check coolant level and condition, adjust
and replace as necessary
5. Check temperature sender wiring and
connector
6. Test temperature sender and replace if
necessary
1. Use the InfoCenter to verify the traction coil
operation (TRACTION OUTPUTS–FRONT
FWD HYDRO)
2. If no amperage reading is displayed:
A. Check the traction coil wiring and
connector
B. Test the traction coil wiring
3. Test the traction coil and replace if necessary
4. Replace T1: TEC (contact your Authorized
Toro Distributor for assistance)
Page 3–8 Outcross 9060
18234SL Rev B