Toro Outcross 9060 Service Manual page 56

Machine Faults (continued)
Fault ID Fault Title
C14A4 Optional
Solenoid
Control Valve
(SCV) Output -
Overcurrent
C14A5 Optional
Solenoid
Control Valve
(SCV) Output -
Open Circuit
Range Hi
C14B0
Output - Fault
Undetermined
C14B3 Range Hi
Output - Short
to Battery
C14B4 Range Hi
Output -
Overcurrent
C14B5 Range Hi
Output - Open
Circuit
Troubleshooting: Attachment/Loader Problems
Controller
Fault Description
Action
Overcurrent detected
on optional SCV output.
Indicates short to
ground.
Open Circuit detected
on optional SCV output.
The fault type is
undetermined due
to hardware restrictions.
Cycling the output will
allow the software to
determine whether the
fault is because of a
short to battery, short
to ground, or an open
circuit.
Low current detected
on range Hi output.
Indicates a short to
battery
Overcurrent detected
on range Hi output.
Indicates short to
ground.
Open circuit detected
on range Hi output.
Recommended Service Actions
1. Check the optional SCV output circuit wiring
and all of the output circuit connectors
2. Test the optional SCV output circuit wiring
3. Test the SCV relay
4. Test all 4 of the hydraulic solenoid valve
SCV coils
5. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
1. Check the optional SCV output circuit wiring
and all of the output circuit connectors
2. Test the optional SCV output circuit wiring
3. Test the SCV relay
4. Test all 4 of the hydraulic solenoid valve
SCV coils
5. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
Cycle the mode selector to LOW and back to
HIGH (key switch in RUN position) to allow the
software to determine the fault type
1. Check the range Hi output circuit wiring and
all of the output circuit connectors
2. Test the range Hi output circuit wiring
3. Test the hydraulic solenoid valve SV1 coil
4. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
1. Check the range Hi output circuit wiring and
all of the output circuit connectors
2. Test the range Hi output circuit wiring
3. Test the hydraulic solenoid valve SV1 coil
4. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
1. Check the range Hi output circuit wiring and
all of the output circuit connectors
2. Test the range Hi output circuit wiring
3. Test the hydraulic solenoid valve SV1 coil
4. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
Page 3–18 Outcross 9060
18234SL Rev B