Toro Outcross 9060 Service Manual page 311

Disassembling the Front PTO Gear Box (continued)
Assembling the Front PTO Gear Box
Installing the Front PTO Gear Box
Outcross 9060
18234SL Rev B
5. Remove the clutch shaft and the output shaft assemblies from the gear box
case together.
6. Remove the plates and shaft seals.
7. Clean the gear box cover and case, removing any old sealant.
1. If previously removed, fit the dowel pins into the gear box case or cover.
g246912
1. Gear box case
2. Stops
3. Brake disc pack tabs
2. Engage the clutch shaft and the output shaft assemblies together. Position
the tabs on the brake disc pack outside of the stops in the gear box case and
install the shafts into the gearbox case together.
3. Install the output shaft assembly into the gear box case.
4. Clean any residue from the gear box and cover mating surfaces with solvent
and apply silicone sealant to only the mating surfaces.
5. Place the wave washers over the clutch shaft and output shaft bearings.
6. Fit the cover over the shaft bearings, wave washers and dowel pins.
7. Apply medium strength thread locking compound and install the socket head
cap screws. Tighten the cap screws in a crossing pattern from 31 to 36
N∙m (23 to 26 ft-lb).
8. Rotate the input shaft by hand to confirm proper gear box assembly.
9. Replace the gear box seals; refer to
7–15).
1. Apply a thin layer of anti-seize lubricant to the splines of the input shaft and
the flywheel adapter.
Note: Long dowel pins are provided to enable shaft spline alignment during
gearbox installation.
2. Fit the gear box to the housing and install the 7 flange head screws. Tighten
screws in an alternating pattern from 46 to 57 N·m (34 to 42 ft-lb).
Figure 126
4. Clutch shaft assembly
5. Output shaft assembly
6. Mating surface
Replacing Front Gear Box Seals (page
Page 7–17 Traction and PTO Drive: Service and Repairs