Honda Fourtrax Rancher AT 2004 Service Manual page 276

FRONT WHEEL/SUSPENSION/STEERING
14-20
INSTALLATION
Pack the lip cavities of the inner dust seal with 2.5 -
3.0 9 of grease.
Install the knuckle over the drive shaft, and onto the
lower and upper arms then inSlalithe castle nuts.
Install the tie-rod ball joint into the knuckle with a
new nut.
Coat a new O-ring with grease and install
it
onto the
knuckle.
Install the brake panel with new bolts.
Tighten the four brake panel bolts.
TORQUE: 29 N·m (3.0 kgf·m , 22 lbf·ft )
Tighten the ball joint castle nuts to the specified
torque and further tighten untif their grooves align
with the cotter pin holes.
TORQU E: 29 N'm (3.0 kgf.m . 22 lbf·ft)
Install new cotter pins.
_ c;;;;;.
12.5 - 3.0 91
SEAL