CRANKSHAFT/AUTOMATIC TRANSMISSION
13-18
Install
8 new O-ring to the breather joint flange.
Install
the crankcase breather joint into the rear
crankcase.
Install
and lighten the breather
joint
bolt.
lnslall
the left engine cover bracket and tighten the
bolts.
Install the dowel pin.
InstaH the primary driven gear with its flange side
facing the automatic transmission.
Temporarily install the centrifugal clutch outer onto
;::===---~=======~~~~~~
the crankshaft.
I
Apply oil to the primary driven gear socket bolt
threads.
Hold the primary drive and driven gear with a gear
holder, then tighten the primary driven gear socket
bolts to the specified
torque.
TOOL:
Gear
holder
07724-0010200
TORQUE:
17 N'm
11.7 kgf·m.
12 IbHtJ
Install the
following:
-
camshaft (page 8-19)
oil pump (page 5-18)
flywheel/starter clutch (page
11-15)
sub-transmission/gearshift linkage (page 12-15)
centrifugal clutch (page
10-10)
cylinder and piston (page 9-8)
cylinder head (page 8-22)
engine (page
7-7)