Install the wire clamp and hose guides as
shown,
and tighten the four screws.
HOSES ... CABLE AND CARBURETOR
HEATEn
If the carburetor heater was removed, install the col
-
lar and carburetor heater with
the
stepped side of
the collar facing
the
carburetor, then tighten the
car-
buretor heater.
If the throttle stop screw cable was
removed,
install
it as follows:
1.
Install the washer and spring
onto
the throttle
stop screw cable.
2. Install the throttle stop screw cable into the
car-
buretor body by turning the screw
knob.
3.
Turn the throttle stop screw knob to align the
butterfly throttle valve with the edge of the
out-
side bypass hole in the carburetor
body.
FUEL SYSTEM
SCREWS
6-19