Honda Fourtrax Rancher AT 2004 Service Manual page 267

FRONT WHEEL/ SUSPENSION/STEERING
ASSEMBLY
Check that the dust seal is in good condition and
replace if necessary.
Coat a new dust seal lip with grease and install
it
into the throttle housing unti l it is fully seated.
Apply grease to the throttle lever pivot in the hous-
ing and the throttle cable end.
Install the washer onto the throttle lever and insert
the throttle lever into the throttle housi ng.
Connect the cable to the throttle arm.
Install the throttle arm with the spri ng over the lever
pivot by align i ng the flat surf aces as shown.
Install a new lock washer and the pivot nut, then
tighten it.
Bend up the washer tab against the nut.
Install the throttle housing cover with a new gasket.
Install and tighten the three screws.
If the throWe cable
Adjust the throttle lever free play (page 4-5).
was replaced. per-
form the InitJa/ set-
rmg (page 24-9)
after ad/ustment
the free play
COVER
WASHER
!'tIl
GASKET
....
14-11