Omron NJ Series Troubleshooting Manual page 186

3 Error Tables
Event code Event name
48020000 hex System Error
58210000 hex Output Con-
trol Timeout
for Parallel
I/O, PLC
Link, or Eth-
erNet/IP
58220000 hex Output Con-
trol Timeout
for EtherCAT
78190000 hex Image Log-
ging Disk
Write Error
781A0000 hex Setting Data
Transfer Error
781B0000 hex Output Buf-
fer Error
(EtherCAT)
88080000 hex PLC Link
Communica-
tions Error
3-124
Meaning Assumed cause
An error occurred in • A serious error occurred in the
the system. system in the Controller.
A timeout occurred • The data output handshaking
in data output hand- controls in the program (i.e., the
shaking control for ON/OFF timing of the DSA sig-
measurement nal) are not correct.
results.
• The output control timeout time
is too short in comparison with
the program processing time.
• The parallel I/O DSA or GATE
signal is not wired correctly.
A timeout occurred • The data output handshaking
in data output hand- controls in the program (i.e., the
shaking control for ON/OFF timing of the Result
measurement Set Request signal) are not cor-
results. rect.
• The output control timeout time
is too short in comparison with
the program processing time.
Writing data to the • A logging disk is not inserted.
image logging disk
• The available space on the log-
failed.
ging disk is not sufficient.
• There is no logging folder.
• Security restrictions are set on
the logging disk.
An error occurred • Scene data was edited when
while transferring there was little available space
the scene data. on the RAM disk and the opera-
tion mode was Single- line
High-speed Mode.
• The data transfer button was
clicked when there was little
available space on the RAM
disk and the operation mode
was Non-stop Adjustment
Mode.
The data output • Data measurements are being
buffer for measure- performed on a period that is
ment data is full. shorter than the time that is
required for data output hand-
shake controls in the program.
A PLC Link cannot • There is a mistake in the PLC
be established. or Vision Sensor communica-
tions settings.
• The Ethernet or RS-232C cable
is damaged.
Level
Maj Prt Min Obs Info
S FH/FZ5 Vision
System
FH/FZ5 Series
User's Manual
for Communi-
cations Set-
tings (Z342)
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
NJ-series Troubleshooting Manual (W503)
Reference