Omron NJ Series Troubleshooting Manual page 161

Event code Event name
90400000 hex Event Log
Cleared
NX-series System Units
The section provides a table of the errors (events) that can occur in the following Units.
NX-PD1@@@
NX-PF0@@@
NX-PC0@@@
NX-TBX01
Event code Event name
00200000 hex Non-volatile
Memory
Hardware
Error
90400000 hex Event Log
Cleared
NX-series Position Interface Units
The section provides a table of the errors (events) that can occur in the following Units.
NX-EC0@@@
NX-ECS@@@
NX-PG0@@@
Event code Event name
00200000 hex Non-volatile
Memory
Hardware
Error
10410000 hex Control
Parameter
Error in Mas-
ter
35100000 hex External
Input Setting
Error
NJ-series Troubleshooting Manual (W503)
Meaning Assumed cause
The event log was • The event log was cleared by
cleared. the user.
Meaning Assumed cause
An error occurred in • Non-volatile memory failure
non-volatile mem-
ory.
The event log was • The event log was cleared by
cleared. the user.
Meaning Assumed cause
An error occurred in • Non-volatile memory failure
non-volatile mem-
ory.
An error occurred in • There is an error in the area of
the control parame- the non-volatile memory in the
ters that are saved Communications Coupler Unit
in the master. in which the control parameters
for the NX Unit are saved.
• The power supply to the NX
Unit was turned OFF or Sys-
mac Studio communications
were disconnected while writing
the control parameters.
A setting for an • The same function (other than
external input is not a general-purpose input) is
correct. assigned to more than one of
the external inputs (I0 to I2).
3 Error Tables
Level
Maj Prt Min Obs Info
S NX-series
Analog I/O
Units User's
Manual
(W522)
Level
Maj Prt Min Obs Info
S NX-series
System Units
User's Manual
(W523)
S Same as
above.
Level
Maj Prt Min Obs Info
S NX-series
Position Inter-
face Units
User's Manual
(W524)
S Same as
above.
S Same as
above.
Reference
3
Reference
Reference
3-99