Preparation Of Printer; Connection Of Printer And Bridge Unit - Epson WF-C20590 Installation Manual

WF-C20590 Installation Guide

PREPARATION OF PRINTER

1. Make sure the printer is turned off and the power cord is unplugged.
2. Pull out the EJ Unit from the printer.
3. Slide the Small EJ Cover, Right toward the direction of the arrow to remove it.
4. Remove one screw (S19: ) to remove the EJ Stacker Shaft, then remove the EJ
Stacker from the EJ Unit.
EJ Unit
EJ Stacker
Small EJ Cover,
Right
5. Remove five screws (S1: /S7: ), and remove the EJ Cover, Lower from the EJ
Unit.
EJ Unit
EJ Cover, Lower
No. Screw types
S1
C.B.S-TITE R, SCREW, 3X8, F/ZN-3C
S7 C.B.S-TITE(P4), SCREW, 3X10, F/ZN-3C
Inside of Small EJ Cover,
Right
EJ Stacker Shaft
No. Screw types
S19 C.B.P-TITE, SCREW, 3X10, F/ZN-3C
PRELIMINARY
Installing the Optional Units

CONNECTION OF PRINTER AND BRIDGE UNIT

6. Insert the ribs of the Bridge Unit Joint Stacker Stopper into the holes of the EJ
unit. Attach the Bridge Unit Joint Stacker Stopper to the hole of the EJ Cover,
Lower removed in Step 5.
7. Use the Stopper Fixing Plate and one screw (S19: ) to attach the Bridge Unit
Joint Stacker Stopper to the EJ Unit.
Hole
EJ Unit
Stopper Fixing Plate
Rib
Bridge Unit Joint Stacker
Stopper
No. Screw types
S19
C.B.P-TITE, SCREW, 3X10, F/ZN-3C
32