Introduction And Specifications; Introduction1; Specifications - Fluke 9100 Series Service Manual

INTRODUCTION
This manual presents service information for the 9100A-017 Vector Output
I/O Module. Included are a theory of operation, general maintenance
procedures, performance tests, troubleshooting information, a list of
replacement parts, and schematic diagrams.

SPECIFICATIONS

Table 1-1 contains the specifications for the Vector Output I/O Module.
Output specifications for Table 1-1 were obtained using
the Y9100-102 Card Edge Interface Module into 10 LSTTL
loads. Results may vary depending on the impedance,
length, and shielding of the connector used. (Output
timing is measured at 50% of signal amplitude.)
Table 1-1. Vector Output I/O Module Specifications
______________________________________________________________________________
VECTOR OUTPUT I/O MODULE OUTPUT
(into 10 LSTTL loads with card edge connector attached):
Module Vector Size ......................... 8192 vectors, 40 channels wide.
Maximum Vector Pattern (4 Modules) ......... 8192 vectors, 160 channels wide.
Vector Looping ............................. Up to 65536 repetitions of
Output Logic Levels:
High ................................... 3.7V minimum (6.0 mA source).
Low .................................... 0.4V maximum (6.0 mA sink).
INT CLK (internal clock) ................... 1, 5, 10, or 20 MHz (±100
DR CLK (external clock) .................... 25 MHz maximum. (This frequency
Clock to Vector Out (tdel):
INT CLK Out to Vector Out Delay ........ 37 ns typical, 45 ns maximum.
DR CLK In to Vector Out Delay .......... 50 ns typical, 58 ns maximum.
______________________________________________________________________________

Introduction and Specifications

NOTE
one vector set.
ppm).
maximum may be exceeded in some
cases based upon application
and hardware interfacing.)
1-1
Section 1