Sagem Ultima 600 Maintenance Manual page 12

S
The tubes are connected as shown in figure 2-6. Rilsan collars are provided on the frame to
guide and keep all the tubes in place.
(1) - Exhaust gas inlet (See fig. 2-7):
• Connect the 80 cm tube to the outlet of the paper filter taking care to run it through
the Rilsan collar on the frame.
• Connect the plastic 90° elbow to the 80 cm tube and to the 7 m tube coming out of
the frame by a hole provided in the lower part.
• Engage the sampling sensor on the other end.
• Roll the gas sampling tube around the bracket provided for this purpose on the left
side of the frame.
• Stow the sampling sensor in its housing.
Inside view of
frame
(2) - Mains power cable:
• Connect the power cable to the power filter.
• Run the cable down along the frame through the hole provided for this purpose after
equipping the cable with a plastic sheath to give it a 90° angle and hold it in this
position without damaging the cable.
• Roll the cable on the lower part of the frame.
(3) - Water evacuation tube:
• The tube is already connected to the unit.
• Run the tube down along the frame, passing it through the same Rilsan collar as the
sampling sensor tube.
• Insert it in the passage provided for this purpose in the lower part of the frame.
Issue 02/99
90° elbow
Exhaust gas
inlet tube
Figure 2-7 - Installing gas
sampling sensor
Sampling
sensor stow
position
Ref.: 21821085-0/A
External view of
frame
2-4