Installing The Printer Paper; Installing The Tubes - Sagem Ultima 600 Maintenance Manual

s
2.1.3 - Installing the printer paper (fig. 2-5)
• Prepare the paper roll by removing the adhesive part (cut around 10 cm off the roll).
• Pull the printer cover lock on the front panel of the unit (to do so, grasp the lower part of
the cover between your thumb and little finger and pull out, taking care to grasp the lower
part of the lock).
• Insert the paper roll in the housing so that the end moves down naturally toward the
bottom (white side downward).
• Pull out a section of paper.
• Close the flap.
• To cut the paper, pull downwards.
Notes:
2.1.4 - Installing the tubes (fig. 2-6)
(1) - Gas
sampling tube
(2) Mains cable
(3) - Pump water
evacuation tube
Sampling sensor
stow bracket
Power cable
stow bracket
Issue 02/99
Only the treated side of the paper will be printed.
Be sure the paper roll is properly positioned.
S AG E M
Figure 2-5 - Installing the printer paper
Figure 2-6 - ULTIMA 600 / REAR PANEL
C
(4) - Gas
evacuation
tube
(5) - Gasoline
engine speed
sensor
(6) – Temp.
sensor
Ref.: 21821085-0/A
SOURIAU
2-3