Setting Up The Unit - Sagem Ultima 600 Maintenance Manual

S
-
Garanty voucher,
- User manual
- Metrology book
Note: The metrology book must always
be kept available to the government
authorities and certified inspectors. This
book contains information relative to
verification and repair of the unit.
8. Lower the unit off the pallet.
9. Stow the pallet.
10. Using a cutter, remove the plastic envelope from the unit.
11. Remove the adhesive protections from the screen and panel.
12. Open the trolley door (fig. 2-4) and check for:
- the warranty voucher,
- the user manual (Ref. 218200705),
- the metrology book.

2.1.2 - Setting up the unit

Work area:
The ULTIMA 600 must be placed:
- near a 230 volts / 50 Hertz / + ground power outlet.
- in a clean, non-corrosive atmosphere; avoid:
. body work preparation areas (sanding, paint),
. battery storage or replacement rooms,
. areas in the vicinity of gasoline flowmeters, washing gantries
. exposure to weather.
Operating temperature range:
+5 °C to +40°C.
Outside these limits, the unit is no longer under normal operating conditions.
Safety:
The power cable must be easily accessible and connected near the unit.
Issue 02/99
Figure 2-4 - Storage compartment for
documents supplied with unit
Ref.: 21821085-0/A
2-2