Xerox AltaLink B80 series User Manual page 52

Getting Started
8. From the list of discovered printers, select your printer, then click Next.
9. If your printer does not appear in the list of discovered printers:
a. Click the IP Address or DNS Name computer icon.
b. Type the IP address of your printer, then click Continue.
c. Select your printer in the list of discovered printers, then click Continue.
10. If your printer was not detected, verify that the printer is powered on and that the Ethernet or
USB cable is connected properly.
11. To accept the print queue message, click OK.
12. Select or clear the Set Printer as Default and Print Test Page check boxes.
13. Click Continue, then click Close.
I I n n s s t t a a l l l l i i n n g g P P r r i i n n t t D D r r i i v v e e r r s s a a n n d d U U t t i i l l i i t t i i e e s s f f o o r r U U N N I I X X , , L L i i n n u u x x a a n n d d A A S S / / 4 4 0 0 0 0
P P r r i i n n t t i i n n g g
UNIX-based printing uses LPD/LPR port 515 or lp to port 9100 to provide printer spooling and
network print server functionality. Xerox
Xerox ® Printer Manager is an application that allows you to manage and print to multiple printers in
UNIX and Linux environments. Xerox
• Configure and check the status of network connected printers.
• Set up a printer on your network and monitor the operation of the printer after installation.
• Perform maintenance checks and view supplies status at any time.
• Provide a common look and feel across the many different suppliers of UNIX and Linux operating
systems.
To print from a Linux workstation, install either a Xerox
You do not need both drivers. Xerox recommends that you install one of the full-featured custom print
drivers for Linux. To locate drivers for your printer, go to www.xerox.com/support/ALB80XXdrivers.
For details about UNIX, Linux and AS/400 printing and drivers, refer to the System Administrator
Guide at www.xerox.com/support/ALB80XXdocs.
I I n n s s t t a a l l l l i i n n g g t t h h e e P P r r i i n n t t e e r r a a s s a a W W e e b b S S e e r r v v i i c c e e o o n n D D e e v v i i c c e e s s
Web Services on Devices (WSD) allow a client to discover and access a remote device and its
associated services across a network. WSD supports device discovery, control, and use.
To install a WSD printer using the Add Device Wizard
1. At your computer, click Start, then select Devices and Printers.
2. To launch the Add Device Wizard, click Add a Device.
3. In the list of available devices, select the one you want to use, then click Next.
Note: If the printer you want to use does not appear in the list, click the Cancel button.
Add the WSD printer manually using the Add Printer Wizard.
4. Click Close.
52 Xerox ® AltaLink
User Guide
® printers can communicate using either protocol.
® Printer Manager allows you to:
® B80XX Series Multifunction Printer
® print driver for Linux or a CUPS print driver.