Network Submenu - Extron electronics TouchLink CCI Pro 700 User Manual

Network Submenu

This submenu (see figures 11 and 12) contains options to configure network settings.
Network settings can be assigned automatically with Dynamic Host Configuration Protocol
(DHCP) or manually by specifying an IP address, subnet mask, gateway address, and
Domain Name Server (DNS) IP address obtained from the network administrator. To finalize
pending changes, press the Context button directly below Apply. To cancel pending
changes, click the Context button directly below Main.
Figure 11.
DHCP — Press the ◄ or ► Navigation button to enable or disable dynamic host
•
configuration protocol (DHCP) (the default is disabled). When enabled, only the host
name can be changed.
• Host name — If DHCP mode is enabled, press the
the host name (63 character maximum). Use the ◄ and ► Navigation buttons to
move the cursor position and the Keypad to enter values.
NOTE: Use the # Keypad button to enter a dash (-) character.
• IP address — Press the
and ► Navigation buttons to move the cursor position and the Keypad to enter
values. The range is 0.0.0.0 to 255.255.255.255 (the default is 192.168.254.251).
NOTE: Use the * Keypad button to enter a period (.) character.
Subnet mask — Press the
•
◄ and ► Navigation buttons to move the cursor position and the Keypad to enter
values. The range is 0.0.0.0 to 255.255.255.255 (the default is 255.255.255.0).
NOTE: Use the * Keypad button to enter a period (.) character.
• Gateway address — Press the
Use the ◄ and ► Navigation buttons to move the cursor position and the Keypad
to enter values. The range is 0.0.0.0 to 255.255.255.255 (the default is 0.0.0.0).
NOTE: Use the * Keypad button to enter a period (.) character.
CCI Pro 700 TouchLink Pro Conference Room Control Interface • Setup Menu
Network Submenu — Page 1
]
Navigation button to edit the IP address. Use the ◄
]
Navigation button to edit the subnet mask. Use the
]
]
Navigation button to edit
Navigation button to edit the gateway address.
13