Table of Contents
Advertisement
Cable Routing
1.
Remove the CCI Pro 700 from the base (see
2.
Pull the twisted pair cable through the opening at the bottom of the base (see figure 8).
Figure 8.
3.
Connect the cable to the LAN and PoE connector (see
4.
Route the cable around the guides of the CCI Pro 700 as shown in figure 9, below.
Figure 9.
5.
Reattach the CCI Pro 700 to the base.
CCI Pro 700 TouchLink Pro Conference Room Control Interface • Panel Features
Routing Cable through the Base Opening
Routing Cable along the Rear Panel
Rear Panel Access
on page 6).
figure
5,
on page 7)
A
10
Advertisement
Table of Contents
