2.
Carefully lift the CCI Pro 700 away from the base.
Figure 4.
Rear Panel Buttons and Connector
Remove the device from the base to access the rear panel features (see
Access
on the previous page).
LAN and Power over Ethernet (PoE) connector
A
Menu button
B
Reset button and LED
C
Figure 5.
LAN and Power over Ethernet (PoE) connector — Connect a twisted pair cable to
A
this RJ-45 connector (see figure 5,
a straight-through cable or a crossover cable (see figure 6 on the next page).
CCI Pro 700 TouchLink Pro Conference Room Control Interface • Panel Features
Removing the CCI Pro 700 From the Base
MENU
RESET
A B C
(see page 9)
(see page 9)
Rear Panel Features
(see below)
above). The Ethernet cable can be terminated as
A
Rear Panel
7