ATTENTION:
•
The CCI Pro 700 is intended for connection to a Power over Ethernet circuit for
intra-building use only and are considered to be part of a Network Environment
0 per IEC TR62101.
•
Le CCI Pro 700 est conçu pour une connexion à un circuit PoE pour une
utilisation intérieure seulement et est considéré comme faisant partie d'un
environnement réseau 0 par IEC TR62101.
•
This product is intended for use with a UL Listed power source marked
"Class 2" or "LPS" and rated 48 VDC (PoE), minimum 0.35 A.
•
Ce produit est destiné à une utilisation avec une source d'alimentation listée UL
avec l'appellation « Classe 2 » ou « LPS » et normée 48 Vcc (PoE), 0,35 A
minimum.
•
Power over Ethernet (PoE) is intended for indoor use only. It is to be connected
only to networks or circuits that are not routed to the outside plant or building.
•
L'alimentation via Ethernet (PoE) est destinée à une utilisation en intérieur
uniquement. Elle doit être connectée seulement à des réseaux ou des circuits
qui ne sont pas routés au réseau ou au bâtiment extérieur.
•
The installation must always be in accordance with the applicable provisions of
National Electrical Code ANSI/NFPA 70, article 725 and the Canadian Electrical
Code part 1, section 16.
•
Cette installation doit toujours être en accord avec les mesures qui s'applique
au National Electrical Code ANSI/NFPA 70, article 725, et au Canadian
Electrical Code, partie 1, section 16.
•
The power supply shall not be permanently fixed to building structure or similar
structure.
•
La source d'alimentation ne devra pas être fixée de façon permanente à une
structure de bâtiment ou à une structure similaire.
Menu button — Press this button (see
B
menu on the LCD screen (see
button, use an Extron Tweeker or small screwdriver.
Reset button and LED — Press this button (see
C
Reset Modes
the CCI Pro 700 (see
use an Extron Tweeker or small screwdriver.
CCI Pro 700 TouchLink Pro Conference Room Control Interface • Panel Features
figure
5,
on page 7) to open the setup
B
Setup Menu
on page 11). To access the recessed
figure
5,
on page 24). To access the recessed button,
on page 7) to reset
C
9