Extron electronics TouchLink CCI Pro 700 User Manual page 31

To replace button labels, perform the following:
1. Remove the CCI Pro 700 from the base (see
2.
Disconnect power from the CCI Pro 700.
3. Remove the seven screws from the rear panel.
Figure 22. Rear Panel Screws
4. Remove the front panel.
5. Place the front panel face down and remove the desired buttons.
Remove Buttons Remove
Figure 23. Button Replacement (Function Buttons)
6. Insert the replacement buttons.
NOTE: Ensure the buttons are positioned correctly. Align the rubber pegs on the
buttons with the holes on the back of the front panel to temporarily hold the
buttons in place.
7. Reconnect the front panel with the same seven screws removed in step 3.
8. Reconnect the power to the CCI Pro 700.
9. Reattach the CCI Pro 700 to the base.
CCI Pro 700 TouchLink Pro Conference Room Control Interface • Reference Information
Rear Panel Access on page 6).
23