Extron electronics TLI Pro 201 Setup Manual

TLI Pro 201 and TLSI 201 • Setup Guide
Overview
The Extron TLI Pro 201 is a TouchLink
within an Extron Pro series control system. The scaled output supports resolutions up to 4K @ 30 Hz. The Extron TLI Pro 201
provides annotation features that allow users to draw, point, or type on video sources during presentations.
The TLSI 201 is a display interface that centralizes information about the TouchLink scheduler system.
This guide provides instructions for experienced installers to mount and install the TLI Pro 201 or TLSI 201 and to create a basic
configuration. For more complete instructions, see the TLI Pro 201 and TLSI 201 User Guide, at www.extron.com.
Setup Checklist
Get Ready
… Download and install the latest version of the following software:
… Toolbelt — Provides device discovery, device information, firmware updates, and configuration of network settings,
system utilities, and user management for TouchLink Pro devices.
TLI Pro 201
GUI Designer — For designing layouts for third party touchpanel interfaces.
…
… Global Configurator
processor and interface.
… Global Scripter
TLSI 201
Room Agent™ — Room booking software for configuring the TLSI 201 for room scheduling.
…
NOTE: All five software programs are available from www.extron.com.
… Obtain the following network information from your network administrator:
… DHCP status — (on or off). If DHCP is off, you must also obtain:
IP address
…
User name — This can be either
…
… Password — The factory configured passwords for all accounts on this device have been set to the device serial
number. Passwords are case sensitive.
NOTE: If the device is reset to default settings, the password will be the default password configuration. The default
password is
… Make a note of the interface MAC address.
Mount and Cable All Devices
Mount the units. Place the interface on a convenient surface, mount it in a standard rack, or use an under-table mounting
…
kit (see the TLI Pro 201 and TLSI 201 User Guide, at www.extron.com). To mount the third-party touchpanel follow the
instructions provided by the manufacturer.
… Connect cables to the interface (see
… Connect the required HDMI source to the HDMI input (TLI Pro 201 only).
Connect the HDMI output from the interface to the third-party touchpanel.
…
… Connect the USB port from the interface to the third-party touchpanel.
NOTE: The USB connection passes information to the interface about where on the screen the touchpanel was
pressed. To use a normal monitor, instead of a touchscreen, connect a mouse to the USB connection. Use the
mouse to click on screen icons.
Interface scaler that integrates a third-party touchscreen display as a point of control
®
Professional and Global Configurator Plus — For setting up and configuring the control
®
— Provides an integrated development environment for Extron control systems programming.
®
Subnet mask
…
admin user
or
extron
(for either admin or user).
Rear Panel Connectors and Features
Gateway
…
.
on the next page).
Product Category
1