Table of Contents
Advertisement
installation
|
66
OPTIONAL LOG SET INSTALLATION
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*Satin dark brown paint is included if touch ups are required.
1
Rear Log
2
Left Log
3
Right Log
4
Front Center Log Piece
5
Front Left Log Piece
Log Brackets x 2
2
5
1. S hut off gas and electrical supply, allow unit to cool to room temperature.
2. Remove fl ush glass door (see unit manual).
3. Carefully remove the logs from the packaging and unwrap them.
The logs are fragile, handle with care -never force into position.
4. Ensure glass crystals are installed on the burner.
E18 = 5lbs
5. Install log brackets by clipping brackets to back of burner tray - measure
4" from outside edge of the burner tray to outside edge of bracket.
4"
Brackets installed 4" from outside edge of burner
919-283
66 |
Regency
®
E18E Gas Fireplace Insert
E18 - LOG INSTALLATION
1
3
4
tray
6. Install Rear Log (1), center log and rest on both left and right log
brackets with pins facing up.
1
Rear log in position
7. Install Log 2 by matching pin locator on Log 2 with left pin on Log 1
as shown below.
2
Log 2 pin locator match
8. Log 2 in position, Log 2 should touch lip of burner approximately 4-1/2"
from the left outside edge of burner tray.
4-1/2"
Log 2 in position
1
1
with Log 1 pin
1
2
E18
02.10.16
Advertisement
Table of Contents
