Regency Energy E18E Owners & Installation Manual page 5

Gas insert
Hide thumbs Also See for Energy E18E:
Table of Contents

Advertisement

This is a copy of the label that accompanies each Regency
printed a copy of the contents here for your review. The safety label is located on the
front inside base of the unit visible when the bottom louver is open.
Note: Regency
units are constantly being improved. Check the label on the
®
unit and if there is a difference, the label on the unit is the correct one.
Please note that with the addition of thermostat control and outside
combustion air supply, this unit is approved for bedroom installations.
For the State of Massachusetts, installation and repair must be done by a plumber
or gasfitter licensed in the Commonwealth of Massachusetts.
For the State of Massachusetts, flexible connectors shall not exceed 36 inches
in length.
For the State of Massachusetts, the appliances individual manual shut-off must
be a t-handle type valve.
The State of Massachusetts requires the installation of a carbon monoxide alarm
in accordance with NFPA 720 and a CO alarm with battery back up in the same
room where the gas appliance is installed.
Gas Insert. We have
®
safety decal
Part #: 919-789c - Side A
Colours: Black on white, except for parts indicated as being Red.
Punch out .25" hole top right corner where indicated.
Size:
100%
w- 3.5" x L- 9.5
Regency
E18E Gas Fireplace Insert
®
Material:
Printable white polyester 7mm
Aug. 10/17:
Created decal
|
5
c
|
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

E18e-lpE18e-ng

Table of Contents