Optional Birch Log Set Installation - Regency Panorama P33CE-NG11 Owners & Installation Manual

Optional Birch Log Set Installation

BIRCH LOG INSTALLATION
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*Paint is included if touch ups are required.
A Rear Log
B Middle Cross Log
C Front Left Cross Log
D Rear Left Log
E Front Right Cross Log
Embers
7 Vermiculite
Rock wool (supplied with unit)
NOTE: If installing the optional Brick Panels, install Panels prior to in-
stalling the logs.
A
B
1. S hut off gas and electrical supply, allow unit to cool to room temperature.
2. Open the front door of the unit, see manual for detailed instructions.
3. Carefully remove the logs from the packaging and unwrap them.
The logs are fragile, handle with care—never force into position.
4. Sprinkle the vermiculite and embers around the fi rebox base.
Vermiculite
Vermiculite
|
48
P33CE-11 Direct Vent Gas Fireplace
919-884
C E
D
Vermiculite
5. Install Log A by lining up the pins on the log bracket with the pin loca-
tors on Log A.
Log A - install on pins on log bracket
6. Install Log B by placing on burner as shown below.
Install Log B
7. Install Log C - rest one end on the 2nd grate tab from the left and
the other end will rest on Logs A + B on a diagonal as shown below.
Install Log C
1
A
A
B
C
P33
07.19.18