Table of Contents
Advertisement
OPERATION
Skip Feed Printing
If the backs of prints are dirty, you
can increase the time between two
1
prints using the {Skip Feed} key. By
default, when one sheet of paper is
fed the drum rotates once. However,
you can select the number of rotations
of the drum. This gives you the
chance to remove prints one by one
from the paper delivery tray or insert
one sheet of paper between two
prints. If you use this function, you
can also use paper longer than 432
mm, 17.0" in spite of the maximum
length limitations of paper.
Note
Two rotations while one sheet of
paper is fed is selected as a default.
You can change this default setting
with the user tools. See "No. of
Skip Feed" in
ting".
The maximum length of paper in
Skip Feed mode is 460 mm, 18.1".
When you use paper longer than
432 mm, 17.0", completed prints
will not be delivered to the paper
delivery tray properly, so lower
the end plate and receive complet-
ed prints by hand.
A
Set your original on the exposure
glass (contact glass) or in the op-
tional document feeder.
70
P.139 "4. Mode Set-
B
Press the { { { { Skip Feed} } } } key.
Stamp
Make-Up
Overlay
Skip Feed
Edge Erase
C
If necessary, select the number of
rotations of the drum while one
sheet of paper is fed with the [ ],
[ ], { { { { ~ ~ ~ ~ } } } } , or { { { { } } } } } } } } key.
Note
You can also select the number
of rotations with the Number
keys.
You can select from 2 to 9 rota-
tions.
By default, the machine asks
you to confirm the number of
rotations. You can have this step
omitted by adjusting the user
tool settings. See "No. of Skip
Feed" in
P.139 "4. Mode Set-
ting".
D
Press the [OK] key.
Image Density
Lighter
On Line
Normal
Darker 1
Darker 2
Tint
Economy Mode
Job Separator
TPES180N
TPES530E
Advertisement
Table of Contents
