Auto Cycle-Making Master And Prints At One Stroke - Savin 3350DNP Operating Instructions Manual

Auto Cycle—Making Master And Prints At
One Stroke
Use the {Auto Cycle} key to process
masters and make prints at one
stroke.
Note
When you use the optional docu-
ment feeder, it is not necessary to
place originals one by one. All
originals are fed and prints are
completed after you press the
{Start} key.
A
Set your original on the exposure
glass (contact glass) or in the op-
tional document feeder.
Note
You can set up to 30 originals
into the optional document
feeder.
B
Enter the number of prints re-
quired with the Number keys.
Program Clear Modes
Enter
Clear/Stop
C
Press the { { { { Start} } } } key.
Program Clear Modes
Enter
Clear/Stop
Auto Cycle
Proof
Print
Start
TPES040N
Auto Cycle
Proof
Print
Start
TPES050N
Auto Cycle—Making Master And Prints At One Stroke
D
Check the image position of the
trial or proof print.
Note
If the image position is not cor-
rect, adjust it using the [Image
=] key (see
Print Image Position").
E
Press the { { { { Auto Cycle} } } } key.
Program
Enter
Clear/Stop
Note
If you press the {Auto Cycle}
key, you cannot make proof
prints by pressing the {Proof}
key.
F
Press the { { { { Print} } } } key.
Program
Enter
Clear/Stop
Note
Repeat steps A through C until
all originals are printed when
you are setting originals on the
exposure glass (contact glass).
P.25 "Adjusting
Clear Modes
Auto Cycle
Proof
Print
Start
TPES150N
Clear Modes
Auto Cycle
Proof
Print
Start
TPES070N
1
49