Entering The Dimensions Of The Original And Print Paper - Savin 3350DNP Operating Instructions Manual

OPERATION
F
Enter the vertical and horizontal
ratio.
1
Note
To change the value entered,
press the {Clear/Stop} key and
enter the new value.
Adjusting ratios with the [ ],
[ ], {~}, or {}} key
A Adjust the vertical ratio with
the [ ], [ ], { { { { ~ ~ ~ ~ } } } } , or { { { { } } } } } } } } key.
B Press the { { { { { { { { } } } } key.
C Adjust the horizontal ratio
with the [ ], [ ], { { { { ~ ~ ~ ~ } } } } , or { { { { } } } } } } } }
key.
Entering the ratios with the
number keys
A Enter the vertical ratio with the
Number keys.
B Press the { { { { Enter} } } } key.
C Enter the horizontal ratio with
the Number keys.
D Press the { { { { Enter} } } } key.
G
Press the [OK] key.
H
Make sure that the original and
the print paper are the correct
size.
I
Set your original on the exposure
glass (contact glass) or in the op-
tional document feeder.
38
J
Press the { { { { Start} } } } key.
Program Clear Modes
Enter
Clear/Stop
K
Check the image position of the
trial or proof print.
Note
If the image position is not cor-
rect, adjust it using the [Image
=] key (see
Print Image Position").
L
Make your prints.
Entering The Dimensions Of
The Original And Print Paper
A
Press the [Ratio] key.
B
Select [Mag.] with the [ ] or { { { { } } } } } } } }
key.
Auto Cycle
Proof
Print
Start
TPES050N
P.25 "Adjusting
TPES570E
TPES570E