Table of Contents
Advertisement
Originals
The following original sizes set on the exposure glass (contact glass) can be de-
tected.
Metric version
Inch version
Under the following conditions, the machine might not detect the original. In
this case, select the original image area with the {Edge Erase} key. See
"Edge Erase—Erasing Edge Margins".
• When you use originals with index tabs.
• When you use OHP transparencies or translucent originals.
• When you use dark originals.
• When you use originals with solid images.
• When you use originals other than the sizes described above.
If you do not lift the platen cover more than 30 cm, 12" when you replace origi-
nals, the machine might not detect the original.
The maximum original size you can set on the exposure glass (contact glass) is
304.8
432 mm, 12"
If you use originals that have bold letters or solid images at the leading edges,
you might get prints with dirty edges. In this case, set the original face down
with the widest margin toward the paper delivery tray or raise the printing
speed.
Set the original after correction fluid and ink have completely dried. Not taking
this precaution could mark the exposure glass (contact glass) and cause marks
to be printed.
Basically, set originals as shown below.
R
R
When you have an optional memory board and the original is set in a different
direction from the print paper, the machine automatically rotates the original
image by 90 to match the print paper direction.
A3L, B4L, A4KL, B5KL
1
11"
17"L, 8
/
"
2
17".
R
R
GRSETT0E
1
14"L, 8
/
"
11"KL
2
Originals
1
P.40
13
Advertisement
Table of Contents
