Copying To Dos - 3Com LANPLEX 6000 User Manual

8 Use the supplied script to decompress and restore the split file (

Copying to DOS

1 Insert the diskette containing the software file into a disk drive (these
2 Copy the software file to the
3 Decompress the file using the following command:
The following files should be in your current default directory:
README1
lp600000
lp600001
lp600002
restore_lpx
and
lp600001, lp600002
# ./restore_lpx
Restoring the split file creates the uncompressed file
readme file for size and checksum information.
The LANplex software for a DOS-based hard disk is distributed on two
floppy diskettes. Diskette #1 contains the LANplex software. Diskette #2
contains the SNMP MIBs.
To copy software to a DOS hard disk, follow the instructions below:
If the directory "lp6000" does not exist on your computer, create the directory
before proceeding.
instructions assume drive B:).
following commands:
cd lp6000
copy b:lp6000.exe
The file lp6000.exe is a self-extracting archive. It decompresses and creates
the loadable lanplex file.
lp6000
This creates a file called
memory.
Copying Software to a Hard Disk
).
directory of your computer using the
lp6000
, which you can then load into flash
lp6000
5-3
lp600000,
. See the
lp6000