Copying To The Ms-Dos Platform - 3Com Corebuilder 6000 Software Installation And Release Notes

8 Insert diskette #4 into the disk drive and extract the fourth part of the file
using the following command:
# tar xvf /dev/rfd0
9 Remove diskette #4 using the following command:
# eject
10 Insert diskette #5 into the disk drive and extract the fifth part of the file
using the following command:
# tar xvf /dev/rfd0
11 Remove diskette #5 using the following command:
# eject
The following files are now in your
README1
lp6000R00
lp6000R01
lp6000R02
lp6000R03
lp6000R04
restore_lpxR
12 Use the supplied script to decompress and restore the split file
(
lp6000R00, lp6000R01, lp6000R02, lp6000R03, and lp6000R04
# ./restore_lpxR
This procedure creates the uncompressed file
file for file size and checksum information.

Copying to the MS-DOS Platform

The CoreBuilder software for an MS-DOS system is distributed on four
diskettes. Install the software using the Windows 95 or Windows NT
operating system.
3Com recommends that you close all Windows programs before running this
Setup program.
Updating Your System Software
directory:
/usr/lp6000R
. See the
lp6000R
5
):
README1