Adding An Analyzer Port - 3Com LANPLEX 6000 User Manual

11-4 C 11: S
HAPTER
Top-Level Menu
system
display
ethernet
add
fddi
remove
tokenring
start
bridge
stop
ip
snmp
analyzer
script
logout
Adding an
Analyzer Port
Top-Level Menu
system
display
ethernet
add
fddi
remove
tokenring
start
bridge
stop
ip
snmp
analyzer
script
logout
S
ETTING UP THE YSTEM FOR
To display the Roving Analysis configurations:
1 From the top level of the Administration Console, enter:
analyzer display
2 Enter the slot number(s) of the module(s) for which you want to display the
Roving Analysis configuration.
The configurations are displayed as shown in the following example:
Ethernet ports configured as analyzers:
Ethernet port
9
Ethernet ports being monitored:
Ethernet port
16
You can have up to 16 network analyzers connected to a system. For a more
accurate analysis, you should attach the analyzer to a dedicated Ethernet
port instead of through a repeater.
To add analyzer ports:
1 From the top level of the Administration Console, enter:
analyzer add
2 Enter the slot number of the module to which the network analyzer is
attached.
3 Enter the number of the Ethernet port to which the network analyzer is
attached.
The MAC address of the analyzer port is displayed. You will need this
information for setting up the port you want to monitor. See the following
example:
Select slot(s) (1-4,8-10):
Select Ethernet port (1-16):
Analyzer port address is 00-80-3e-0a-3b-02
R A
OVING NALYSIS
Ethernet address
00-80-3e-0a-3b-02
Ethernet address
00-80-3e-0a-3b-02
9
9