Removing Trap Destinations - 3Com LANPLEX 6000 User Manual

3-26 C 3: C
HAPTER ONFIGURING
Address Error
Top-Level Menu
system
ethernet
display
fddi
mode
display
tokenring
community
addModify
bridge
trap
remove
ip
flush
snmp
smtProxyTraps
analyzer
script
logout
M A
ANAGEMENT CCESS
The trap numbers you enter allow the trap specified by that number to be
sent to the destination address or agent(s) when the corresponding event
occurs. Any traps that are not listed are not transmitted to the destination
when the corresponding event occurs.
The following example shows a trap configuration for a system in single
agent SNMP mode:
Enter the trap destination address:
Enter the trap numbers to enable (1-10,12-22|all)
all
[1-10,12-22]:
The following example shows trap configuration when the system is in
multiple agent SNMP mode:
Select dst proxy agents or address (dstAgents,dstAddress)
[dstAddress]: dstAgents
Select agent(s) by slot (2-3|all) [2-3]:
Enter the trap numbers to enable (1-10,12-22|all)
all
[1-10,12-22]:
If the destination address you entered is not a valid end station or the agent
does not have a route to the destination, you will receive the following
message:
Trap address invalid or unreachable

Removing Trap Destinations

When you remove a destination, no SNMP traps will be reported to that
destination.
To remove a destination:
1 From the top level of the Administration Console, enter:
snmp trap remove
If the system is set for single agent SNMP mode, you are prompted for a
trap reporting destination address. If the system is set for multiple agent
SNMP mode, you are prompted for either a destination agent or a
destination address.
2 Enter the SNMP trap reporting destination agent or address you want to
remove at the prompt.
The destination agent(s)/address is removed and you are returned to the
previous menu.
T T S
O HE YSTEM
158.101.222.3
2