3Com LANPLEX 6000 User Manual page 114

9-8 C 9: A
HAPTER DMINISTERING
Top-Level Menu
system
display
station
ethernet
connectPolicy
path
fddi
tNotify
mac
tokenring
statusReporting
port
bridge
backplane
ip
snmp
analyzer
script
logout
FDDI R
ESOURCES
Table 9-3 Bit to Set for Rejecting a Station Connection (continued)
Connection Rejected...
(port - Remote port)
B-M
S-A
S-B
S-S
S-M
M-A
M-B
M-S
M-M
To set the connection policies of an FDDI station:
1 From the top level of the Administration Console, enter:
fddi station connectPolicy
You are prompted for a slot related to the FDDI station.
2 Enter the slot(s) related to the FDDI station(s).
You are prompted for a station.
3 Enter the station for which you want to set the connection policies.
4 Enter the value of the connection policy for that station.
The value is a 16 bit number with the appropriate bit(s) set for each
connection type that you want to reject.
See the following example:
Select station [1]:
Station 1 - Enter new value [8000]:
If This Bit
Is Set Connection Rules
7 Tree connection with possible redundancy.
The node shall not go to Thru state in CFM.
In a single MAC node, Port B shall have
precedence (with defaults) for connecting
to a Port M.
8 Undesirable peer connection that creates a
wrapped ring; notify SMT.
9 Undesirable peer connection that creates a
wrapped ring; notify SMT.
10 Connection that creates a single ring of two
slave stations.
11 Normal tree connection.
12 Tree connection that provides possible
redundancy.
13 Tree connection that provides possible
redundancy.
14 Normal tree connection.
15 Illegal connection that creates a tree of rings
topology.