Unassigning Packet Filters From Ports - 3Com LANPLEX 6000 User Manual

14-24 C 14: C
HAPTER
Unassigning
Packet Filters
from Ports
Top-Level Menu
system
list
display
ethernet
display
mode
fddi
create
ipFragmentation
tokenring
delete
ipxSnapTranslation
bridge edit
addressThreshold
ip load
agingTime
snmp copy
stpState
analyzer assign
stpPriority
script
unassign
stpMaxAge
logout
addressGroup
stpHelloTime
portGroup
stpForwardDelay
port
packetFilter
U P
REATING AND SING ACKET
In the example below, the assignment is to the transmit all (txA) and receive
all (rxA) paths on port 1 of slots 3 and 4.
Select filter [1-n]:
Select slot(s) [3-5, all]:
Select port type(s) (Ethernet,FDDI|all) [Ethernet,FDDI]:
FDDI
Select port(s) (1-16|all) [1-16]:
Select path(s) (txA,txM,rxA,rxM|all):
The slots are limited to those that have the filter loaded and have at least
one port/path unassigned. The ports are limited to those that have at least
one path unassigned, while the paths are limited to those that are
unassigned. Because you can specify multiple selections at each level, you
can assign a wildcard that attempts to assign the filter to the set indicated
by the slots, ports, and paths taken in combination.
One or more assignments may fail due to a previous assignment.
To unassign a packet filter from one or more ports, the packet filter must
have been previously assigned to at least one port.
To unassign a packet filter:
1 From the top level of the Administration Console, enter:
bridge packetFilter unassign
2 Enter the id number of the packet filter to unassign.
3 Enter the slot number of the packet filter to unassign.
4 Enter the port type (
5 Enter the port number of the packet filter to unassign.
6 Enter the path of the packet filter to unassign.
An example of unassigning a packet filter is shown below. In this example,
the unassignment is from the transmit all (txA) paths on port 1.
Select filter [1-n]:
Select slot(s) [3-5, all]:
F
ILTERS
1
3,4
, ,
Ethernet FDDI all
1
3,4
1
txA,rxA
).