Setting/Deleting An Snmp Group; Setting The Source Address Of Trap; Adding/Deleting A User To/From An Snmp Group - 3Com Switch 4500 26-Port Configuration Manual

Setting/Deleting an
SNMP Group
Setting the Source
Address of Trap
Adding/Deleting a User
to/from an SNMP Group
Table 320 Set the Engine ID of a Local or Remote Device
Operation
Set the engine ID of the device
Restore the default engine ID of the device. undo snmp-agent local-engineid
By default, the engine ID is expressed as enterprise No. + device information. The
device information can be IP address, MAC address, or user-defined text.
You can use the following commands to set or delete an SNMP group.
Perform the following configuration in System View.
Table 321 Set/Delete an SNMP Group
Operation
Setting an SNMP group
Deleting an SNMP group
You can use the following commands to set or remove the source address of the
trap.
Perform the following configuration in System View.
Table 322 Set the Source Address of Trap
Operation
Set the source address of trap
Remove the source address of trap
You can use the following commands to add or delete a user to/from an SNMP
group.
Perform the following configuration in System View.
Table 323 Add/Delete a user to/from an SNMP Group
Operation Command
Add a user to an SNMP
snmp-agent usm-user { v1 | v2c } username
group.
groupname [ acl acl-list ] snmp-agent usm-user v3
username groupname [ authentication-mode { md5 |
sha } authpassstring [ privacy-mode { des56
privpassstring } ] ] [ acl acl-list ]
Delete a user from an
undo snmp-agent usm-user { v1 | v2c } username
SNMP group.
groupname undo snmp-agent usm-user v3 username
groupname { local | engineid engine-id }
Command
snmp-agent local-engineid engineid
Command
snmp-agent group { v1 | v2c } group-name [
read-view read-view ] [ write-view write-view
] [ notify-view notify-view ] [ acl acl-list ]
snmp-agent group v3 group-name [
authentication | privacy ] [ read-view
read-view ] [ write-view write-view ]
[notify-view notify-view ] [ acl acl-list ]
undo snmp-agent group { v1 | v2c } group-name
undo snmp-agent group v3 group-name [
authentication | privacy ]
Command
snmp-agent trap source interface-name
interface-num
undo snmp-agent trap source
Configuring SNMP 283