Address And Main/Sub Setting - Daikin RZQ Series FCQ20EVA Service Manual

Wireless Remote Controller
2.3

Address and MAIN/SUB Setting

Introduction
To set the wireless remote controller, you have to set the address for:
 The receiver of the wireless remote controller
 The wireless remote controller.
Setting the Address for the Receiver
The address for the receiver of the wireless remote controller is factory setting to 1. To change this setting,
proceed as follows:
Set the wireless address switch (SS2) on the PCB according to the table below.
Unit No.
Wireless address
switch (SS2)
When using both a wired and a wireless remote controller for 1 indoor unit, the wired controller should be set
to MAIN. Therefore, set the MAIN/SUB switch (SS1) of the receiver to SUB.
For FCQ, FBQ
MAIN/SUB
MAIN/SUB
switch (SS1)
Setting the Address for the Wireless Remote Controller
The address for the wireless remote controller is factory setting to 1. To change this setting, proceed as
follows:
1. Hold down the "
button for at least 4 seconds to get the Field Setting mode.
(Indicated in the display area in the figure at right.)
2. Press the "
(A/b). Each time the button is pressed the display
switches between "A" and "b".
3. Press the "
1 2
Address can be set from 1 to 6, but set it to 1 ~ 3 and to
same address as the receiver. (The receiver does not
work with address 4 ~ 6.)
4. Press the "
5. Hold down the "
quit the Field Setting mode and return to the normal
display.
15
No. 1 No. 2
MAIN SUB
S
S
M
M
" button and the "
" button and select a multiple setting
FAN
" button or " " button to set the address.
UP
DOWN
3 4 5 6
" button to enter the setting.
RESERVE
" button for at least 1 second to
/TEST
No. 3
"
/TEST
Mode
Address
Multiple
setting
SiME281501E
3
2
4
1
5
Remote Controller