Names And Functions - Daikin RZQ Series FCQ20EVA Service Manual

SiME281501E
1.2

Names and Functions

1.2.1 BRC1C61
ON/OFF BUTTON
1
Press the button and the system will start.
Press the button again and the system will stop.
OPERATION LAMP (RED)
2
The lamp lights up during operation.
DISPLAY "
CONTROL)
3
When this display shows, the system is UNDER
CENTRALIZED CONTROL.
DISPLAY "
(VENTILATION/AIR CLEANING)
4
This display shows that the total heat exchange
and the air cleaning unit are in operation
(These are optional accessories).
DISPLAY " " "
(OPERATION MODE)
5
This display shows the current OPERATION
MODE. For cooling only type,
and " " (Heating) are not installed.
DISPLAY "
TEST
OPERATION)
6
When the INSPECTION/TEST OPERATION
BUTTON is pressed, the display shows the
system mode is in.
hr
DISPLAY " " (PROGRAMMED TIME)
hr
7
This display shows the PROGRAMMED TIME
of the system start or stop.
DISPLAY " " (SET TEMPERATURE)
C
8
This display shows the set temperature.
DISPLAY " " (FAN SPEED)
9
This display shows the set fan speed.
DISPLAY " " (AIRFLOW FLAP)
10
DISPLAY " "(TIME TO CLEAN AIR FILTER)
11
Remote Controller
7
6
8
14
16 15
" (UNDER CENTRALIZED
" " " " " " "
" " " " " " "
" " (Auto)
" (INSPECTION/TEST
5 12 4 2 1
17 18 22
DISPLAY "
12
NON-FUNCTIONING DISPLAY
If that particular function is not available, pressing
the button may display the words "NOT
AVAILABLE" for a few seconds.
13 When running multiple units simultaneously the
"NOT AVAILABLE" message will only be appear
if none of the indoor units is equipped with the
function. If even one unit is equipped with the
function, the display will not appear.
TIMER MODE START/STOP BUTTON
14
TIMER ON/OFF BUTTON
15
INSPECTION/TEST OPERATION BUTTON
16
This button is used only by qualified service
persons for maintenance purposes.
PROGRAMMING TIME BUTTON
Use this button for programming
17
STOP" time.
TEMPERATURE SETTING BUTTON
18
Use this button for SETTING TEMPERATURE.
FILTER SIGN RESET BUTTON
19
FAN SPEED CONTROL BUTTON
Press this button to select the fan speed,
20
HIGH or LOW, of your choice.
OPERATION MODE SELECTOR BUTTON
21
Press this button to select OPERATION MODE.
AIRFLOW DIRECTION ADJUST BUTTON
22
NOTE
• For the sake of explanation, all indications are shown
on the display in the above figure contrary to actual
running situations.
Wired Remote Controller
3
9
11
10
13
21
20
19
" (DEFROST)
"START and/or
C: 3PA59583-16Z
8