Changing The Electronic Control Unit; Important Point; Method For Tep 96 Version 1.5. Before July 1998; Method For Tep 96 Version 2.0. After July 1998 - PEUGEOT E1A Workshop Manual

CHANGING THE ELECTRONIC CONTROL UNIT

Important point:

- Only do this job if the ECU is being changed
- Before starting any work, the memory of the ECU to be replaced must be copied into the TEP 96
1. Connect the TEP 96 and turn on the ignition.
2. Parameter memorisation
Method for TEP 96 version 1.5. before July
1998:
Select the "Exchange uce" line from the main
menu and confirm
OTHER FUNCTIONS
♦ Reading variables
♦ Exchange uce
⇑ Exchange battery
Reproductions or translations, even parrtial, are forbidden without the written consent of Peugeot Motocycles
ELECTRONIC CONTROL UNIT REPLACEMENT

Method for TEP 96 version 2.0. after July 1998:

Select the "SPECIAL FUNCTIONS" line from
the main menu and confirm
OTHER FUNCTIONS
♦ Ιdentity UCE
♦ Ιdentity TEP
⇑ SPECIAL FUNCTIONS
To access the special functions, press on the 2
buttons on the bottom of the TEP 96 for a
minimum of 3 seconds.
TO OPENING SPECIALS
FUNCTIONS
REQUEST AGREEMENT
PEUGEOT MOTOCYCLES
Then confirm on the "Exchange uce" line.
SPECIAL FUNCTIONS
Exchange uce
Exchange battery
Page: 32