PEUGEOT E1A Workshop Manual page 22

From previous page
on
Disconnect
the charging
cable and
open the
maintenance
hatch and
slowly add
demineralised
water
Close the hatch,
the lamps flash
YES
Reproductions or translations, even parrtial, are forbidden without the written consent of Peugeot Motocycles
TROUBLESHOOTING LOGIC DIAGRAM
After this charge, the charge and
maintenance lamps are:
off
Read fault
codes
If there is a fault
refer to the
corresponding
logic diagram
NO
flashing
On the TEP96, check the
charge current see
machine does not charge
100% logic diagram
No fault there has
maybe been a power
failure during the
procedure recommence
the battery
maintenance procedure
Change the
battery hatch
switch
Recommence a
battery maintenance
procedure
charge on and
fault warning
flashing
see logic
diagram
machine does
not charge
Page: 22