Regulator/Temperature Control Unit/Starter Motor Relay/Cdi Unit/Starter Resistor; Checking The Ignition System - PEUGEOT Django 125 Workshop Manual

Regulator/Temperature control
unit/Starter motor relay/CDI unit/Starter
resistor
- Remove the upper RH fairing. See:
Procedure 6. page 21.
- Removal:
• Regulator (1)
• The starter motor relay (2)
• The temperature control unit (3)
• The ignition module (4)
• The starter resistor (5)

Checking the ignition system

Disconnect the ignition unit and take the
measurements on the harness side.
- Between the green wire and the ground: 0 Ω.
- Between the green/black wire and the ground
(Ignition sensor) : 195 Ω
- Between the yellow/black wire and the earth
(High voltage primary coil) : 0.5 Ω
- Between the black wire and the ground, ignition
on: 12V (Battery voltage).
If the values are correct, replace the ignition
module.
If the values are incorrect, check:
- The harness.
- The ignition switch.
- The kickstand contactor.
- The high voltage coil:
• Primary: 0.5 Ω
±20%
• Secondary: 3.7 KΩ
• Spark plug socket: 5 KΩ
coil:
- The ignition sensor: Between the green/black
wire and the ground: 195 Ω
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
±20%
.
±20%
.
.
±20%
.
±20%
. Low voltage
±20%
.
2
5
1
ELECTRICITY
3
4
75