SERVICE OPERATIONS
SERVICE OPERATIONS
Changing the engine oil
The engine must be drained when it is
warm to allow the oil to run easier.
Put on protective gloves.
- Place the vehicle on its central stand on flat
ground.
- Remove the engine's oil filler cap (1).
Remove the drainage cap and its
seal (2) and allow the oil to drip into a
recipient.
- Remove the strainer cap (3) and clean the
strainer.
- Insert the drain plug fitted with a new seal.
Tightening torque: 20 Nm.
- Re-install the filter cap fitted with a new seal.
Tightening torque: 30 Nm.
- Pour the required quantity of oil
corresponding to the manufacturer's
standards into the filler hole.
Quantity: 0.8 l.
- Start the engine and let it run for a short
while.
26
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
2
3