Abs/Pbs System Bleed Method; Bleeding The Front And Rear Circuits After Changing The Control Unit - PEUGEOT Elystar Workshop Manual

ABS/PBS SYSTEM BLEED METHOD

Bleeding the front and rear circuits after changing the control unit

- Fill the control unit reservoir with brake fluid
before fitting to the machine
- Fit the control unit into its mounts without
securing it
- Connect the hydraulic hoses to the control unit
- Remove the control unit from its mounts so that
it is as vertical as possible
Rear brake circuit (main brake)
1) Protect any plastics which may be exposed to
brake fluid splashes
- Remove the left master cylinder cover
- Position the handlebar in order to create a high
point on the master cylinder to enable the bubbles
in the circuit to rise more easily
- Check the brake fluid level in the master cylinder
and top up if necessary.
Note: It is essential to avoid being under the
master cylinder during bleeding to avoid brake
fluid splashes
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
WORKING ON THE ABS/PBS SYSTEM
Page : 33